LED bracket lights can be said to be quite common lighting fixtures. This type of bracket light is almost an essential item in households, but for some homeowners, they are not familiar with the installation and wiring methods of LED bracket lights. Sometimes, even after looking at the installation instructions for a long time, they still make mistakes during installation. If the installation goes wrong, it can cause a lot of trouble for our use. In this article, I will provide a detailed introduction to the characteristics of LED bracket lights and their installation methods!

What are the characteristics of LED bracket lights?

1. The LED bracket light has a built-in power supply for the lamp tube, allowing for direct installation of LED tubes without modification.

2. The LED bracket light uses an external power supply. Remove the original ballast, replace it with a LED power supply, connect the wires, and install the LED lamp.

3. It is important to note whether the LED bracket light's lamp tube is powered from both ends or from one end. For dual-end power, both ends are connected to the power supply; for single-end power, only one end is powered, but attention must also be paid to the polarity.

Precautions for installing LED bracket lights:

1. When installing and maintaining LED bracket lights, ensure that the power is turned off before operating.

2. LED bracket lights should only be installed on non-combustible surfaces, and insulating pads or similar materials should not cover the surface of the fixture at any time.

3. The wiring of the LED bracket light should be correct: the red wire connects to the live wire, the green wire connects to the ground wire, and the blue wire connects to the neutral wire, ensuring a secure connection.

4. After the wire enters the LED bracket light through the outlet loop, the outlet loop should be tightened to prevent rainwater from seeping into the fixture when used in an inverted position.

5. The environment for using LED bracket lights should be free of corrosive, flammable, and explosive materials.

6. The components connecting the LED bracket light to its bracket should be sturdy to prevent accidents caused by the usage environment and other factors.

After reading my introduction, I believe everyone has a good understanding of this type of lighting fixture. You can always consult our professional editors. If you want to purchase LED bracket lights, you can also contact us at Tansuo!

Telephone:18914779750

Fax: 025-84199977

E-mail:njtansuo@163.com